We try to maintain our quality standards because we believe that today we are able to exist in the industry only because of the strict quality parameters we maintain to manufacture all our machines.
Following are some parameters on the basis of which our range is checked:
» Dimensional accuracy
» Durability
» Strength
» Corrosion-resistance
» Performance
» Sturdiness
Installation
- Place the machine on a horizontal levelled clean floor and adjust the levelling screws to make sure machine is rigid and not shaking.
- Remove the magnetic slide side cover and add Castrol MAGNATEC 15W-40 Diesel Engine Oil only so that V guideway is completely dip and there is a 2-3mm thick oil layer over the Flat guideway.
- Make machine’s electrical connections to the startor & check the wheel rotation as indicated on wheel cover.
- Before starting the machine lubricate the slides & screws by pumping lubrication pump.
- Dress the grinding wheel, with the help of diamond dresser in toolkit.
- Now your machine is ready for operation.
Trouble Shooting
- In case any taper is observed in work piece, check the magnet surface using dial indicator (within 0.01mm/ full length of magnet). If any surface damage or taper is observed, grind the table slowly with light cuts (max 0.05 mm).
- In case vibration is observed, dress the wheel. Also check the spring tension of spindle after removing the wheel cover.
- In case of any uneven movement in vertical slide, remove the covers of vertical slides & clean with diesel or equivalent oil & lubricate properly.
Preventive Maintenance Schedule
| Particulars | Daily | Monthly | Annually |
|---|---|---|---|
| Cleaning & Oiling |  |
||
| Check oil level in magnet slide | |
||
| Oil level in lubrication pump | |
||
| Cleaning of vertical slides by removing front & rear covers | |
||
| Check the motor & spindle for any undue noise | |
||
| Greasing of Spindle (if required call service engineer) |
|
||
| Grind the magnet surface (very light cuts (max 0.05 mm) |
|